Stapler making process

Small stapler, convenient office and study, how did he make out?Below by China stapler factory for you to explain:

Part one:

Cuboid length, width and height are 48, 24 and 4 respectively.The slot is 43 in length, 17 in width, 3.5 in margin, 2 in radius and 1 in depth.The lug radius is 1.5 and 2.5 respectively, the center is 23 apart, the center of the small circle is 3.5 according to one side and the height is 1.The radius of the fillet is 2.The results are as follows:

Stapler making process

Part two:

Draw the following sketch with the tensile thickness of 1

Stapler making process

Select one side of the solid as the sketch plane and draw the next sketch.

Stapler making process

Then mirror the other half and punch holes in the fillet. The result is as follows:

Stapler making process

Part three:

Draw a solid body with length, width and height of 43,15 and 1, and draw the following sketch on its side:

Stapler making process

And stretch 1, mirror, finally chamfer hole, the result is as follows:

Stapler making process

Part four:

Draw the following sketch:

Stapler making process

After stretching (stretching 8, mirror range!)After the detailed operations such as groove and fillet, the results are as follows:

Stapler making process

Part five:

Draw the following sketch:

Stapler making process

Stretch (6.5 choose mirror range), after the operation of groove, convex head fillet, plate, etc., the result is as follows:

Stapler making process

Part six:

Draw two connected bosses with a radius of 2 and a thickness of 0.6 for the large circle, 1.5 for the small circle and a thickness of 2.3. The results are as follows:

Stapler making process

Part seven:

Draw sketch 1 (outline) and sketch 2 (guide line) respectively, as follows:

Stapler making process

Through rib and box body (thickness 1.5), after rounded corners and excision, the results are as follows:

Stapler making process

Part 8:

Helical operation is carried out in the wireframe module, the pitch is 0.6 and the height is 10. After adding the vertical coil, scan the operation with the rib command, and the result is as follows after details processing:

Stapler making process

At this point, finished, the required stapler required parts parts finally finished!!!Finally, the assembly operation, the process does not need to say, as long as the corresponding constraints and the relationship between each other.By simple movement, the assembly can be completed with conjunctions and contact constraints.

Finally, you can add materials and render desktop stapler, the results are as follows:

Stapler making process


Post time: Oct-21-2019
WhatsApp Online Chat !